SpeakerCraft VBX Owner's Manual download pdf

VBX Tabletop Stereo Volume

Control

The SpeakerCraft VBX is a tabletop stereo volume control. It connects between the speaker level output of

an amplifier, receiver or speaker selector and a pair of speakers.

Caution: If you do not understand any part of these instructions please contact your SpeakerCraft

dealer. Improper wiring could cause damage to your audio system.

Control Placement

When deciding where the volume control will be placed, consider the various ways it will be used. The pri-

mary listening area and the ease of running the wire to your chosen location are the important things to keep

in mind. The most common locations to place the volume control are next to other stereo components, at your

bedside or near your telephone. The VBX features special suction feet that help prevent the control from mov

ing once it is placed.

Wiring the VBX60

Caution: Please make sure your amplifier or receiver is off before proceeding.

The VBX features a removable terminal connec

tor. This simplifies connecting the speaker wires to

the control. For best results use speaker wire that

is at least 18 gauge, for runs longer than 75 feet

14 gauge wire is recommended. Wire larger than

14 gauge is not recommended because it may

not fit into the connector. For best results strip all

wire insulation no more than 3/8" from the end

before inserting into the connector.

1. Pull the terminal from its location on the back

of the cabinet. This will make it easier to

connect the wires. (Figure #1)

2. Connect the amplifier's or receiver's speaker

outputs to the appropriate location under

"AMPLIFIER” on the removable terminal. Please

observe proper polarity (+, -) of the

connections. (Figure #2)

3. Connect the wires from the speakers to the

appropriate location under "SPEAKERS" on the

removable terminal. Please observe proper

polarity (+, -) of the connections. (Figure #2)

Caution:

If the "AMPLIFIER" and "SPEAKERS" connections

are reversed the minimum setting on the volume

control would present a short across the amplifier

or receiver output terminals. This may seriously

damage your amplifier or receiver. Please double-

check all connections before turning your ampli

fier or receiver on. Do not connect the VBX in

series with another volume control.

REMOVABLE CONNECTOR

FRONT

REAR

VOLUME CONTROL KNOB

Figure #1

STEP 1.

STRIP SPEAKER OR AMPLIFIER

WIRE'S INSULATION TO 3/8"

FROM THE END AND

INSERT INTO PROPER

SLOT.

STEP 2.

TIGHTEN WIRE CLAMP SCREW

WITH SCREWDRIVER.

AMPLIFIER WIRES

SPEAKER WIRES

STEP 3.

INSTALL PLUG INTO

BACK OF VBX BOX.

Figure #2

OWNER’S MANUAL

SpeakerCraft

1 2

Summary of Contents

Page 1 - SpeakerCraft

VBX Tabletop Stereo VolumeControlThe SpeakerCraft VBX is a tabletop stereo volume control. It connects between the speaker level output of an amplifie

Page 2 - Limited Lifetime Warranty

Operation:1. Make sure your receiver or amplifier is off and the volume is set to the lowest level.2. Turn the knob on the front of the VBX clockwise

Comments to this Manuals

No comments

SpeakerCraft VBX Owner's Manual

Browse online or download Owner's Manual for Remote controls SpeakerCraft VBX. SpeakerCraft VBX User Manual

Summary of Contents

Comments to this Manuals

Related products and manuals for Remote controls SpeakerCraft VBX