SpeakerCraft VST45 Owner's Manual download pdf

Stereo Volume Control

OWNERS MANUAL

SpeakerCraft

Volume Control

The SpeakerCraft VST-45 is a wall mount

stereo volume control. It connects

between the speaker level output of an

amplifier, receiver or speaker selector and

a pair of speakers.

Caution:

If you do not understand any part of

these instructions please contact your

audio dealer. Improper wiring could

cause damage to your audio system.

Control Placement

When deciding where the volume con-

trol will be mounted in the wall, consider

the various ways it will be used. The

primary listening area and the ease of

running the wire to your chosen location

are the important things to keep in mind.

The most common locations to mount volume controls are by the door as you walk into the room, next to

existing wall fixtures, or in the area that you will be listening to music.

Do not put the control into the same box as a 110VAC circuit. (i.e. light switch, electrical outlet, etc.) Speaker

wires can act as an "antenna" for electrical noise. Locating speaker wires too close to a light switch or dimmer

may cause a buzzing or popping sound to be heard through the speakers. If you must locate the VST45 near

electrical devices, use a separate electrical box.

Once a location has been chosen, you may install the control by using a standard single gang plaster ring, or

a single gang electrical box (light switch type).

Wiring the VST45

(See Figure #1)

Caution: Please make sure your amplifier or receiver is off before proceeding.

1. Connect the amplifier's or receiver's left speaker output to the left side of the input terminal (marked AMP)

on the volume control. Connect the amplifier's or receiver's right output to the right side of the input terminal.

Please observe proper polarity of the connections (+ to +, - to -).

2. Connect the left speaker cable to the left speaker output terminal (marked SPEAKER). Connect the right

speaker cable to the right speaker output terminal on the volume control. Please observe proper polarity of the

connections (+ to +, - to -).

Caution:

If the input and output connections are reversed the minimum setting on the volume control would present

a short across the amplifier or receiver output terminals. This may seriously damage your amplifier or receiver.

Please double check steps 1 and 2. This volume control cannot be connected in series with another volume

control.

LEFT

Speaker

Outputs

AMPLIFIER

INPUT

WIRES

OUTPUT

WIRES

RIGHT

BOTTOM

VIEW

VST45

VOLUME

CONTROL

+ - - +

- ++ -

SPEAKER

L+ L - R- R+

AMP

L+ L- R- R+

SPEAKERS

1.) PUSH WIRE INTO

TERMINAL HOLE

2.) TIGHTEN SCREW

TERMINALS

Figure #1

VST45

1 2

SpeakerCraft 1
LIT90148 (rev1) 2

Summary of Contents

Page 1 - SpeakerCraft

Stereo Volume ControlOWNERS MANUALSpeakerCraft®Volume ControlThe SpeakerCraft VST-45 is a wall mount stereo volume control. It connects between the sp

Page 2 - LIT90148 (rev1)

Mounting the VST45(See Figure #2)Once the control has been wired it is ready to be mounted into the wall. Place the com-ponents of the control into th

Comments to this Manuals

No comments

SpeakerCraft VST45 Owner's Manual

Browse online or download Owner's Manual for Remote controls SpeakerCraft VST45. SpeakerCraft VST45 User Manual

Summary of Contents

Comments to this Manuals

Related products and manuals for Remote controls SpeakerCraft VST45